Athletics and Recreation

2019 Ford F-150 Aftermarket Wheel and BFGoodrich KO2 Tire Installation

2019 Ford F-150 Aftermarket Wheel and BFGoodrich KO2 Tire Installation


step bars are a great addition to any
truck not only does it provide easy entrance in and out of your vehicle but
they add some Flair and protection as well we went with Weston’s HDX drop step
for our f150 with features like solid one-piece steel design notch steps and
rugged punch plates they’re the perfect choice for our f150 in this video we’re
going to show you how to install these steps on our f150 now let’s get to work
we’re gonna start this process by going under the truck and locating all the
step bar studs we’re gonna be inserting these plastic washers on the studs the
purpose of these washers is to create a barrier between the aluminum body of the
truck in the steel step to prevent corrosion repeat this process and all
the step bar studs under the truck the second step in our process to pre
assemble the brackets by taking the bolt flat washer locking washer and nut and
we’re just going to loosely assemble these and we’ll tighten them in the
final process repeat this step on all six brackets our Center mounting bracket
has an offset in it not to be confused with our end mounting brackets on either
side make sure to take note of the orientation of our brackets because they
will fit in multiple locations and not be correct we’re going to go flat washer
split washer and nut and repeat this process on all three
bolts make sure not to tighten these down all the way and just snug them up
we’ll come back and tighten them all the way later just repeating the same process as
before next we’re gonna hang the step bar on
the brackets next we’re going to start to install the
hardware on the step bars we can go through and start all the bolts coming back to
tighten them later repeat this process on all six holes now we’re going to proceed you’re
torquing the brackets we’re going to work from the top of the bracket to the
bottom torquing it to the specification in the instructions now that this side is done repeat the
process on the other side we just finished up the install of our
Westin HDX step bars only took us about 60 minutes and a few tools to
throw them on so with a little bit of time and some good old elbow grease you
could have a step bar with the form feel and function that any truck owner
will love thanks for watching they offer a great flare protection they
offer great we just finished up the install of our Westin HG extra 1 piece solid
steel design they offer the we went with Weston’s
HDX drops


Reader Comments

Leave a Reply

Your email address will not be published. Required fields are marked *